PRO TOP1 960W 24V 40A Switch-Mode Power Supply Unit - Weidmuller
High-end power supplies must perform efficiently and reliably, even in challenging industrial environments. This requires high power reserves, a long service life and optimal protection against overvoltage, vibration and extreme temperature conditions. New DCL technology gives PROtop an outstanding dynamic range. This can be used for the reliable triggering of circuit breakers or for powerful motor starts.
Product Specifications
Input
Â
AC input voltage range
85…277 V AC
Connection system
PUSH IN
DC input voltage range
80 ... 410 V DC
Dielectric strength
max. 300 V AC ≤ 15 s
Frequency range AC
45…65 Hz
Input fuse (internal)
Yes
Inrush current
max. 15 A
Power factor input
> 0.9
Rated input voltage
100 - 240 V AC / 120 - 340 V DC
Surge protection
Varistor
Output
Â
DCL - peak load reserve
150 % (5 s); 400 % (15 ms)
Connection system
PUSH IN
Mains failure bridge-over time
> 20 ms @ 115V AC/ 230 VAC
Output power
960Â W
Output voltage
24Â V
Output voltage
22.5...29 V
Parallel connection option
Passive Current Sharing
Protection against inverse voltage
Yes
Ramp-up time
≤ 100 ms
Rated (nominal) output current @ UNom
40 A @ 60 °C
Rated output voltage
24 V DC ± 1 %
Reserve capacity @ URated
130% permanent at ≤ 40°C
Residual ripple, breaking spikes
< 50 mVss @ UNenn, Full Load
Triggerable circuit breakers
B6, B10, B16, B20, B25, C2, C4, C6, C10, C13
General Data
Â
AC failure bridging time @ INom
> 20 ms @ 230 V AC / > 20 ms @ 115 V AC
Degree of efficiency
94%
Derating
> 60°C (2.5% / 1°C)
Earth leakage current, max.
3.5Â mA
Housing version
Metal, corrosion resistant
MTBF
> 1.000.000 h according IEC 1709 (SN29500)
Mounting position, installation notice
Horizontal on DIN rail TS 35, top and bottom 50 mm clearance for free air flow, 10 mm clearance to neighbouring active subassemblies with full load, 5 mm with passive neighbouring subassemblies, direct row mounting with 90% rated load
